Pumping Water Around

Ok it's been more than a few days...The salt mixture was a little anemic and so I had to slowly increase the salt concentration to get it to 1.023. To get out the dirty water from the aquariums, I graduated from 5 gallon buckets to a Python No Spill Clean and Fill. They are actually on SALE right now at Drs Foster and Smith. Though they have good prices every day, this SALE makes this a no brainer purchase.

The Python is connected to the bathroom sink faucet in place of the aerator. With the valve in one position and the water turned on, the water will be sucked out of the aquarium and directly into the sink. It takes about 15 minutes to pump out 30 gallons of water and vac the entire substrate. You can do this with both fresh and saltwater tanks. Man does it save your back from hauling 5 gallon buckets of water around. That's 12 bucket trips saved with a 30 gallon water change!!!

Once the water is out, it's time to pump in fresh water into the aquarium. The valve is switched to pump mode and water is pumped directly into the aquarium. You need to adjust the water temp first to match your tank but it's not difficult to do with a thermometer. You also need to add a dechlorinator to the filling stream so you don't stress out your fish too much. I add in Amquel+ 1 teaspoon every 10 gallons as I go. Before long, the tank is full and clean and hardly a drop of water was spilled.

This is where things diverge for the Saltwater tank. Since the new salt water is mixed ahead of time, this has to get pumped back into the aquarium and the Python won't do it by itself! I use a magnetic pump safe for saltwater use. It was trial and error on the pump size as the distance, height of the tank above the ground, hose diameter, etc all play a part in how fast the water gets from point A to point B. In my particular instance, a 700 GPH pump gave me the best flow, not too fast and not too painfully slow. Using some spare parts, also ordered from Drs Foster Smith, I fabricated a host that would simply screw onto the end of the python hose and then attach to the pump.

After I'm certain that the temp and salinity are the same as the tank, I plug in the pump and fill the tank. I've done this for years, 30 gallons at a time (about 50%), and never had any issues with my corals or livestock.

Using the Python and a pump is HUGE back saver. I would never before have considered cleaning both 65 gallon tanks on the same day. That's 24 trips with the buckets. With the Python I can get both tanks done from drain to fill in just a couple of hours. After all, I would rather spend my time enjoying the aquariums than hauling buckets all weekend. It's important to simplify your processes with aquariums, especially very large ones. I guess that goes for having any kind of pet. The less time you have to put in doing maintenance, the more you can enjoy what you have.

Coming soon, more time saving processes and a little more about my aquarium inhabitants.